CPU:		Intel FW80219M600
dual UART:	TA550C - Serial port controller
flash:		Intel TE28F128 (16MiB)
USB:		Via VT6212L
SATA:		Silicon Image Sil3512ECTU128
NICs:		Realtek RTL8110SB (2x)
rtc:		Ricoh RS372 (i2c)
fan control:	Fintek F75375S (i2c)
leds:		Philips PCA9532 (i2c)


datasheets:
- TA550C generic TI 16550C (48 tqfp)
- VT6212L http://www.via.com.tw/en/products/peripherals/usb/vt6212/
- RTL8110SB ftp://202.65.194.18/cn/nic/rtl8169rtl8169sbrtl8110sb/spec-8110sb(160).pdf
- Fintek F75375S http://www.fintek.com.tw/files/productfiles/2005111152950.pdf
- PCA9532 http://www.semiconductors.philips.com/pip/pca9532


GPIOs:
7	SCL I2C bus			O
6	SDA I2C bus			I/O
5	power button			I
4	full hardware reset		O, external pull-up
		(drive low to reset)
3	software reset button		I
2	reset to pca9532		O, external pull-up
		(drive low to reset, high or float to deassert reset)
1	factory test mode		I
0	copy button			I

I2C addressing:
0x2e	F75375S
0x32	RS372
0x52	SPD EEPROM
0x60	PCA9532

PCA9532, Philips LED controller
15	buzzer (0 to enable)
14	system fail led
13	system busy led
9	system reset		=> doesn't seem to do anything
8	power off
7	usb fail led
2	usb link led
1	sata hd fail led
0	sata hd fail led


PCI interrupt routing:
device		IDSEL	slot	int routing
RTL8169-1	17	1	XINT0
RTL8169-2	18	2	XINT3
Sil3512		19	3	XINT2
VT6212		20	4	INTA->XINT1 (iff J3), INTB->XINT0, INTC->XINT2
Mini-PCI	21	5	XINT3
UART		-	-	XINT1 (iff J4)

	J3/J4 control XINT1 interrupt routing
	J3	VT6212 INTA to XINT1
	J4	UART interrupt to XINT1